An E-47 rebuild kit like no other! We put together the most complete rebuild kit for the E-47 Meyer Snow Plow Pump you will find anywhere. This is a good deal, as it includes all you need and then some to completely rebuild your E-47. Including: ALL basic seals and O Rings (DOES NOT INCLUDE ANY O RINGS FOR DRAIN PLUGS, OR PILOT CHECK PLUGS), all Valve O Rings, the Crossover Valve Seal Kit, Genuine Meyer Top Cap Guide Bushing, Genuine Meyer Pump Shaft Seal, NEW Bosch Type Motor Carbon Brushes (DOES NOT FIT PRESTOLITE MOTORS), and 3 new Nylock Nuts to hold the Top Cap on, and 3 new Nylock Nuts to hold the Pump on, and two new BRASS Nuts to hold the B and C Coils on with 2 new Lock Washers, and a NEW Nylock Nut to hold the Lift Ram Piston/Follower/Packing on. Also (NOT PICTURED) a new ground bolt and tooth washer, motor base gasket, motor cap gasket, Genuine Meyer Filters, Genuine Meyer Fill Plug/Vent, and flange lock nut for the motor stud. Download the E-47 Service Manual off the Meyer web site for FREE to assist you. www.meyerproducts.com