5,000 PSI Liquid Filled Pressure Gauge, includes adapter to screw in to HighPressure Port on Meyer E-47, E-57, E-58H, and E-60 pumps. Also fits H Models. Adapter will not fit older E-47 units with 5/8" Drain Plugs. It can still be used on them, but must..

This tool is used to hold the Pump Check Valve in place when installing the E-60 Pump back into the E-60 Housing.

Heat Shrink Tubing DUAL Wall thickness, Adhesive Lined, 1/2" diameter. Bundle of (8) pieces approximately 12" long. Red or black. BE SURE TO Choose color under Options, or we will send black. READ FULL DESCRIPTION PLEASE.

Heat Shrink Tubing DUAL Wall thickness, Adhesive Lined, 3/8" diameter. Bundle of (6) pieces approximately 12" long. Red or black. BE SURE TO Choose color under Options, or we will send black. READ FULL DESCRIPTION PLEASE.

This is a Flex Hone to help clean the rust and pits out of the Pivot Pin Tubes when replacing Pivot Pins. Pic is a general representation of the Flex Hone.

Meyer E-46, E-47 Pump Relief Valve

Check Valve for Meyer E-47/57/60 pumps. Special Tool required to install in E-60 pumps. Special Tool is available here in our store. Check "Related Items".

Meyer E-57, E-58H, E-68, E-78, E-88 Pump Relief Valve.

This is a Flex Hone used to Hone the E-60 (Smaller Diameter 1-1/8") Lift Cylinder. Removes rust and pits. Will not remove bad pits, but will smooth them out.

Adapter to fit High Pressure Filter Port on Meyer Plow Pumps. Will NOT fit older E-47 units that have 5/8" plugs. Fits E-47, E-57, E-58H, E-60, E-78, E-68, E-88. Also fits H Models. Other end of adapter has 1/4" NPT.

This is the Thread Sealant we use daily in our shop. It is rated at 10,000psi. Teflon tape should never be used on plow hydraulic systems. The penny is to show the size of the tube.